Antenna Instalation Method

In my company, I was get this paper from RBS (Radio Base Station) department.
I want to share the knowledge for you.

First Method for Antenna Clamps

1. Take out "guide/tlit clamp" fom the carton box
2. Attached the guide/tilt clapm on the inside surface of antenna with using 3/8' bolt and washer
3. Tilt clamps must be attached as direction that indicated in picture. (Towards to connector) ...But I can't give u a picture.

Second Method for Antenna Installation

1. Release the nuts in order to insert the ANTENNA Mast Pipe.
2. Fasten the nuts after insert the ANTENNA Mast Pipe

Third Method for Antenna Installation

1. Release the nuts
2. Set to the wanted angle
3. Fasten the nuts

Directional Antenna (ACS-15-90B-2)

Assembly and Mounting Instruction

Poduct Description

The ACS-15-90B series antennas are 15dBd+0.5dB gain, 90 + 5 derajat 3 - dB beamwidth and directional antennas. The series offers vertical polarization and is used in the 824-894 MHz. The brassplated radiation elements are enclosed in aesthetically pleasing, high impact, weather and UV resistant ASA radome. In addition, this series can be applied to various kinds of mounting types.

Instalation Instructions

1. Remove the antenna from the shipping package and verivy that all items are enclosed and that there is no physical damage. (refer to included item list)


2. Brackets and clamps are pre-assembled by manufacture before shipping.


3. Inspect the antenna feed assembly output connector to determine that it mates with the station transmission line. Do not remove any connector from the antenna feed assembly, it is part of the antenna.


4. Release the nuts in order to insert the antenna mast pipe, and disassemble clamp covers from guide and tilt clamps.


5. Attach clamps of the antenna to the pole.


6. Fasten the nuts after attach the clamps and double check all the nuts securely in order not to not to make the antenna slip down.

Caution:

When loosen and fasten nuts, use 3/8-inch hand wrenh but not apply heavy force. Be sure that proper torque is 23Nm.

1. When down tilting is needed, loosen two nuts on tilt clamp first.


2. Loosen the nuts either of two nuts on the guide clamp


3. Tilt the antenna down by hand until angle scale indicates that you desire. Verity the angle sclr on the tilt clamp, while tilting the antenna down.


4. If the antenna is not adjusted enough, loosen the rest on the guide clamp.


5. Repeat step 11 again


6. After setting the antenna to the desired tilt angle, tighten all nuts on guide and tilting clamp

Warning

1. Installation of this product near power lines is dangerous. For your safety, follow proper installation procedures.


2. Do not paint the radome of the antenna

Source: Acetech